Wednesday, November 11, 2009

Work continues on the CT.

For the bottom legs, I needed to make the mortises, so I used a 5/8" forstner bit.

A bit of work with the chisel(s) gets the round holes square.

The tenons for the legs & bottom rail were cut at the bandsaw. (Didn't use a handsaw, kind of wimped out I guess...)

Tonight it was time to create the 2 mortises for the top. The router only wandered a couple of minute times, but nothing that the middle piece won't cover up.

Almost ready to go, just need to square the ends and make sure everything fits.

No comments:

Post a Comment